Adjusting The Volume; Selecting Layouts And Input Sources - Planar UltraRes URL109-MFT User Manual

Note: The display may automatically turn off the LEDs or enter standby mode if no signal is
present for a certain period of time. See the description of the Power Saving Mode setting on
page 89 for more information.

19.7 Adjusting the Volume

6. Using the remote, press the vol + or vol - to increase or decrease the volume. The Up and
Down keys on the remote and keypad can also be used to increase or decrease the
volume.
7. Press the mute button to temporarily turn off all sound. To restore the sound, press the
mute button again.
Note: The analog audio out is variable. S/PDIF is fixed.
19.8

Selecting Layouts and Input Sources

With Planar MediaPlex Plus Processing, one source at a time can be shown or multiple sources
can be shown simultaneously. Multiple layout options are available and can be selected from
the Inputs and Views Menu (see page 80). Once a layout has been designated, sources can be
assigned to each of the zones in the layout. The selection of sources must be made one at a
time by assigning a current zone. To select the current zone, navigate through the on-screen
menu (see page 80). Alternatively, use the remote or keypad as described next.
Remote
Press the Zone 1, Zone 2, Zone 3, or Zone 4 buttons on the remote. After selecting the desired
zone, press the source button (DP, HDMI 1, HDMI 2, HDMI 3, or HDMI 4). This action will also
select the active audio source.
For example, to change Zone 3 to DP, press the Zone 3 button and then press the DP button.
Keypad
Press the SRC/Source button. The input source will be toggled sequentially.
Note: Sources will toggle through the current zone, or last zone to be modified. Current zones
can only be re-assigned in the on-screen menu.
Planar UltraRes L Series 109" User Manual
020-1434-00A
78
Page | 78