Table of Contents
Advertisement
19.2 Locking the Keypad and IR Remote
The keypad and IR remote functionality can be locked on the display. To lock the keypad, go to
Main Menu -> Advanced Settings -> System Settings and select Keypad Lock. To lock the IR
remote, go to Main Menu -> Advanced Settings -> System Settings and select IR Remote Lock.
19.3 Unlocking the Keypad and IR Remote
To unlock the keypad, press the following keys on the keypad in the order listed: UP, UP,
RIGHT, LEFT, DOWN. If the IR remote is unlocked, unlocking the keypad can be done by using
the IR remote to go to Main Menu -> Advanced Settings -> System Settings and uncheck
Keypad Lock.
To unlock the IR remote, press the following keys on the IR remote in the order listed: UP, UP,
RIGHT, LEFT, DOWN. If the keypad is unlocked, unlocking the IR remote can be done by using
the keypad to go to Main Menu -> Advanced Settings -> System Settings and uncheck IR
Remote Lock.
19.4 Changing the IR Remote Code Set
The IR remote code set transmitted by the remote and accepted by the display can be
configured. This is useful if there are multiple Planar displays in the installed area and each
display needs to be operated independently. It can also be used if IR interference with another
device, such as a DVD player, is occurring.
To change the IR code on the remote, use the following procedure:
1. Press and hold the CODE button on the remote control until the LED on the remote
lights solid red (approximately five seconds).
2. Enter a new five-digit code between 00000 and 65535. Include leading zeros for codes
with four or fewer digits; for example, enter 255 as 00255.
3. The LED turns off to confirm the code change. If an invalid code was entered, the LED
flashes for three or four seconds. Try again, entering a valid code.
Note: The code must match the IR Remote ID Code setting. See page 108.
19.5 Turning the Display On
1. Insert the power cord into the display and into the power outlet.
2. Ensure the AC switch is set to "—".
3. Press the ON button on the remote or the power button on the keypad.
19.6 Turning the Display Off
With the power on, press the OFF button on the remote or the power button on the keypad to
put the LED panel in a standby mode. To turn off power completely, turn the AC switch to "O" or
disconnect the AC power cord from the power outlet.
Planar UltraRes L Series 109" User Manual
020-1434-00A
Page | 77
Advertisement
Table of Contents
