Led Module Removal - Planar UltraRes URL109-MFT User Manual

11. LED Module Removal

1. For removal of LED modules, a suction tool is provided in the accessory kit. Be sure the
rocker switch is on and that the battery has been charged. To remove a module, follow the
steps below:
a. Place the tool in the orientation shown in the center of a module to be removed
and gently apply pressure
b. Press the button at the top of the handle. The button may be released and the
suction will continue.
c. Pull the module straight out perpendicular to the display.
2. To remove a module from the tool, support the back of the module with one hand while
pressing the button again. The suction will turn off and the module will be free to place in a
protected place while working on the display.
3. To replace a LED module, the tool is not required. Using both hands, line up the LED
module with the open area of the display and carefully bring closer to the display. The
magnetic force from the display will pull the module into place. If an edge does not seat
properly, then the module may need to be removed and re-positioned again. Never force a
LED module into place; this can cause damage to an adjacent or the LED module being
installed.
Planar UltraRes L Series 109" User Manual
020-1434-00A
63
Page | 63