Steps
1. Route the VGA cable through the VGA module slot on the front of the system and slide the VGA module into the slot.
2. Align the hole on the module with the screw hole on the system.
3. Using the Phillips #1 screwdriver, secure the VGA module to the system with the screw.
Figure 87. Installing the VGA module
Next steps
1. Route the VGA cable and connect it to the VGA connector on the system board. For locating the connector, see the
board jumpers and connecters
2.
Install the air
shroud.
3.
Install the backplane
cover.
4.
Install the front
bezel.
5. Follow the procedure listed in the
.
Optional optical drive
Removing the optical drive
The procedure for removing an optical drive and optical drive blank is the same.
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. If installed,
remove the front
Steps
1. Disconnect the power and data cables from the connectors on the optical drive.
NOTE:
Observe the routing of the cable as you remove it from the system.
2. To release the optical drive, press the release tab and push the drive towards the front of the system.
3. Slide the optical drive out of the system.
88
Installing and removing system components
section.
After working inside your
Safety
instructions.
Before working inside your
bezel.
system.
system.
System