Image is reversed
•
To reverse the image, enable rear projection by selecting "Installation > Orientation > Direction > Rear
Projection" from the OSD menu.
The projector stops responding to all controls
•
If possible, turn off the projector, then unplug the power cord and wait at least 60 seconds before
reconnecting power.
If the remote control does not work
•
Check if the operating angle of the remote control is pointed within ±30° (front and back) to the remote
receivers on the projector. Make sure there are any obstructions between the remote control and the
projector.
•
Check the remote batteries. Make sure batteries are inserted correctly. Replace the batteries if they are
used up.
•
Ensure you have set the correct IR code to the remote control. See "Remote Settings" in the chapter
"Communication", page
14.2 LED indication chart
Overview
Image 14–1
1
AV Mute LED
2
Status LED
3
Light LED
Explanation
Message
Standby State
Power on
(warm up)
Power on & Laser
diode on
Power off (cooling
down)
AV mute is off
(image is displayed)
72.
1
2
3
Light LED
Orange
Green
Red
Steady
Steady
Status LED
Orange
Green
Red
Flash-
ing
Steady
Flash-
ing
Steady
Troubleshooting
AV Mute LED
Orange
Green
Steady
Steady
R5914653 /10
G62
87