Page 1
BARCO PROJECTION SYSTEMS UNI-TCR G6300 R9001440/9 ADJUSTMENT MANUAL Date: 09/02/2000 Order No. R5976123 Rev:00...
Page 2
Due to constant research, the information in this manual is subject to change without notice. Produced by BARCO NV, May 1999. All rights reserved. Trademarks are the rights of their respective owners. BARCO n.v./Projection Systems Noordlaan 5 B-8520 Kuurne Belgium Tel.: +32/56/368211...
Page 5
R9001440/9 ADJUSTMENT MODE é ê to highlight Push the Select a path from below : 'Service' and then press ENTER. RANDOM ACCESS INSTALLATION Some items in the Service mode are pass- SERVICE word protected (when the password function Select with SERVICE is active).
Page 6
R9001440/9 SERVICE IDENTIFICATION CHANGE PASSWORD CHANGE LANGUAGE CHANGE PROJ. ADDRESS CHANGE BAUDRATE PC RESET LAMP RUNTIME LAMP RUNTIME HISTORY DIMMING MORE... é ê Select with CHANGE BAUDRATE PC then <ENTER> <EXIT> to return. 230400 115200 57600 38400 19200 9600 4800...
Page 12
R9001440/9 ADJUSTMENT MODE Select a path from below : RANDOM ACCESS INSTALLATION SERVICE Source 01 Select with RANDOM ACCESS then <ENTER> ADJUSTMENT MODE <EXIT> to return. FILE SERVICE PICTURE TUNING AUDIO TUNING GEOMETRY PICTURE TUNING Select with then <ENTER> CTI [ON] <EXIT>...
R9001440/9 ADJUSTMENT MODE Select a path from below : RANDOM ACCESS INSTALLATION SERVICE SERVICE Select with then <ENTER> IDENTIFICATION <EXIT> to return. CHANGE PASSWORD CHANGE LANGUAGE CHANGE PROJ. ADDRESS CHANGE BAUDRATE PC RESET LAMP RUNTIME LAMP RUNTIME HISTORY DIMMING MORE...
Page 27
R9001440/9 ADJUSTMENT MODE Select a path from below : RANDOM ACCESS INSTALLATION SERVICE é ê to high- Push the light 'Service' and then press ENTER. SERVICE Select with then <ENTER> IDENTIFICATION <EXIT> to return. CHANGE PASSWORD Some items in the Service mode are CHANGE LANGUAGE CHANGE PROJ.
Page 28
R9001440/9 é ê to adjust Use the the Red Black Level and the cursor key ç è Continue with the adjustment of the WHITE BALANCE: PRESET INPUT BALANCE é ê to highlight 'White Balance' Push the WHITE BALANCE and then press ENTER.