Barco G62 User Manual page 57

• Side by side
• Top and bottom
• Frame sequential
3D tech
Select a proper 3D technology according to how the 3D sync signal is processed:
• DLP-Link:
Select DLP-Link when the 3D sync signal is generated by the DLP Link technology built-in the projector.
DLP-Link works only with the glasses that are compatible with DLP 3D technology and the 3D function is
enabled.
• 3D sync:
Select 3D sync when the 3D sync out signal is sent to an emitter or another projector through the 3D sync
out port.
3D-2D
Transform the 3D content to 2D images.
• 3D:
Play the 3D content normally.
• 2D-left:
Play the left images of the 3D content.
• 2D-right:
Play the right images of the 3D content.
3D sync in select
Specify the source of the 3D sync input signal:
• Auto:
If an external 3D sync input is detected, the projector automatically uses the external sync input. If no
external 3D sync input is detected, the projector uses the internal 3D sync to display the content.
• Internal:
The projector generates the 3D sync internally to display the content.
• External:
The projector uses an external 3D sync input to display the content.
3D sync out
Set up the transmission of the 3D sync output signal:
• To emitter:
Send the 3D sync signal to the emitter connected to the 3D sync out port.
• To next projector:
Send the 3D sync signal to the next projector when using multiple projectors.
3D invert
Use this function to invert the 3D left and right frames, when the 3D video does not appear correctly.
Frame delay
Set a frame delay value for the projector to correct the time difference between the 3D signal being given and
the result being executed.
This function only works when L/R Reference is set to Field GPIO.
When performing 3D blending on multiple projectors, set the frame delay for each projector to correct the non-
synchronous images.
Reset
Reset the 3D settings to their factory default values.
User controls – Installation menu
R5914653 /10 G62 57