Auto Hdmi Switch; Hdmi; Auto Signal Resync; Projection Native Timing - Barco G62 User Manual

User controls – Source menu

7.5 Auto HDMI switch

About auto HDMI switch
When Auto HDMI Switch is enabled, input source must be either "HDMI1" or "HDMI2".
HDMI2 has a higher priority over HDMI1!
If a signal is detected on HDMI2, then the displayed signal will switch to HDMI2 and only switch back
to HDMI1 after removing the HDMI2 signal.

7.6 HDMI

About HDMI
Setup the projector's HDMI ports.
Output
Select an I/O port to output the signal.
EDID
When receiving an HDMI signal, set the projector's EDID compatibility to display the signal correctly.
Select "1.4" for the input devices with HDMI1.4, or "2.0" for HDMI2.0 devices.
HDMI1
Select the HDMI EDID type for the HDMI1 port.
HDMI2
Select the HDMI EDID type for the HDMI2 port.

7.7 Auto signal resync

About auto signal resync
Once enabled, the system will automatically synchronize the projector to the most recently connected input
source every time you switch the input source.

7.8 Projection native timing

About projection native timing
The projectors native timing can be changed to:
• 1920x1200 @60Hz (default)
• 1920x1080 @60Hz

7.9 Reset

About reset
Reset all source settings to their factory default values.
46 R5914653 /10 G62