Powering Off The Projector - Barco G62 User Manual

Image 5–4
Note: The EULA
4. Turn on your source. The projector detects the source you selected and displays the image.
Note: If you connect multiple input sources at the same time, press the Input key on the control
panel or on the remote control to switch inputs.
WARNING: Do not look directly into the lens when the projector is on. The strong light may cause
permanent eye damage.

5.2 Powering Off the Projector

How to power Off the projector
1. Press the POWER button (2) on the control panel or the OFF key (5) on the remote control, a message
displays on the screen.
MENU
LENS
FOCUS
Image 5–5
2. Press the POWER button or OFF key again to confirm, otherwise the message disappears after 5
seconds and the projector remains on.
CAUTION: Don't power on the projector again immediately after entering standby mode.
can be downloaded from the Barco website.
EXIT INPUT
ENTER
Powering On/Off the projector
5
ON OFF
1 2 3
4 5 6
R5914653 /10 G62 37