Panasonic F10 MARK II Operating Instructions Manual page 33

(4)
(5)
WHITE
When the white level is unbalanced, the blinking WHITE is
displayed.
If the White Balance Selection Switch is set to the AWC
position and press the White Balance Set Switch while
aiming the camera at the white object such as wall or Paper
and confirm that the blinking WHITE disappears.
In the ATW operation, if the camera is used beyond the
ATW
operating
range (approximately
2600°K - 6500°K},
the blinking WHITE appears. In this case, use the camera in
the AWC made.
(6)
LIGHT 2.
When the light level becomes insufficient, the blinking (1)
LIGHT is displayed.
Additional lighting is required.
— 28 —
Note: The priority order for the warning/alarm graphics
is BATT > BACKUP —> TAPE —> WHITE —~>
LIGHT for VHS VTR, and REC WARN —> BATT
— > BACKUP ——> WHITE —> LIGHT for 3/4"
VTR and S-VHS VTR.
The lower priority warning/alarm will function
after resolving the higher priority warning/alarm.
When 3/4' VTR or S-VHS VTR is connected to 14 pin on
this camera, some of the warning signals generated from
VTR will be displayed on the viewfinder.
FUNCTIONAL DISPLAY
Strobe Effect Shutter Display
When the Strobe Effect Shutter/Normal Selection Switch
{14) on the camera is set to the SES position, the blinking
SES is displayed for indicating strobe effect shutter mode.