Panasonic F10 MARK II Operating Instructions Manual page 15

22.
23.
24.
25.
26.
Colour Adjustment (GAIN R/B)
GAIN switch to OFF position
The red and blue colours are balanced by adjusting these
control and preset at the centre position which usually
provides accurate colour reproduction.
GAIN switch to ON position
However, under some conditions it may be necessary to
compensate by adjusting these controls.
To obtain the best possible colour, set these controls at the
centre position in both the AWC and ATW white balance
mode,
Backup Battery Compartment
The backup battery RO3 (AAA size) is installed into this
compartment to memorize the internal title and also to
function the date and time continuously when the camera
power source is off.
Audio Level Selection Switch (AUDIO -20dB/-60dB)
Two audio output levels for the VTR can be selected :
-20dB or -60dB. It is factory-set to the -20dB posjtion.
Stereo Earphone Jack (M3) (EAR)
When the stereo earphone (not provided) is connected, the
stereo microphone sound of the camera can be monitored.
When the mono earphone (not provided) is connected, the
CH1 (L) mono microphone sound of the camera can be
monitored.
32-Pin Connector
This connector is for a connection of an optional AC
adaptor WV-PSO3, Gen-lock adaptor WV-AD36E or RCU
adaptor WV-AD37E,
27.
28.
29.
30.
31,
"4102
DC Power Selection Switch (DC POWER: EXT, 10P, 14P)
This switch selects the power of the camera as follows;
EXT: This position is used for selecting the power
source either from AC adaptor WV-PS0O3,
RCU adaptor WV-AD37E or Gen-lock adap-
tor WV-AD36E.
10-Pin VTR Connector (VTR)
Portable VHS VTR shall be connected here.
(Composite signal only)
VTR Compatibility Switch (RUN, 4 /=)
The logic level of the camera trigger may be incompatible
and reversed, so that the VTR pauses when it should run
and vice versa. In this case, set the switch position to other
side.
When this camera is connected with Panasonic portable
VTRs, set the switch to # position.
When this camera is connected to a VHS portable VTR of
another manufacturer, set the switch to © position,
Note: Set the VTR Compatibility Switch (RUN 4/2)
on the camera to the # position when using the
RCU, 3/4" VTR or S-VHS VTR.
S-VIDEO OUT
S-VHS signals (Y/C) are fed from this connector.
14-pin VTR Connector (14P)
A portable VTR which has 14-pin camera connector shall
be connected here.
The output video signal is set to either composite or Y/C
signal by 14P Output Signal Selector (11).