Copy Ports Options - Paradyne Hotwire 8775 User Manual

Copy Ports Options

You can copy the configuration options of one synchronous data port and DSL
loop to another using the Copy Ports screen. For Copy Ports options, refer to
Table A-3, Copy Ports
selection sequence:
Table A-3. Copy Ports Options
8700-A2-GB25-10
Options. To access the Copy Ports screen, follow this menu
Main Menu Configuration
From: Port
Possible Settings: 1, 2, 3, 4
Default Setting: 1
Controls the source of the configuration options.
1– 4 – The configuration of the selected port is copied.
To: Port
Possible Settings: 1, 2, 3, 4, All
Default Setting: 2
Controls the target of the configuration options.
1– 4 – The configuration of the selected port is replaced. If Perform Copy Then
Increment is selected, the port number is incremented by 1 after the copy.
All – The configurations of all ports are replaced by the configuration of the selected
From: Port.
NOTE: Peer IP Address and Circuit Identifier are not copied.
February 2001
Current Configuration Copy Ports
A. Configuration Options
A-7