Configuring Snmp Traps - Paradyne Hotwire 8775 User Manual

6. Messages and Troubleshooting

Configuring SNMP Traps

An SNMP trap can be automatically sent out through the EOC or the Management
port to the SNMP manager when the termination unit detects conditions set by the
user. These traps enable the SNMP manager to gauge the state of the network.
Refer to
traps supported by the unit.
To configure the unit for SNMP traps, use the SNMP Traps Options screen to:
T
T
T
T
To configure SNMP Traps, follow this menu selection sequence:
Refer to
information about these options.
6-2
Appendix B, Standards Compliance for SNMP
Enable SNMP traps.
Set the number of SNMP managers that receive SNMP traps from the unit.
Enter an IP address and network destination for each SNMP manager
specified.
Select the type of SNMP traps to be sent from the unit.
Main Menu Configuration
Management and Communication
main/config/management/trap
Slot: 4
SNMP Traps: Enable
NMS 1 IP Address: 135.014.040.001
NMS 2 IP Address: 135.014.003.027
NMS 3 IP Address: 135.014.001.008
NMS 4 IP Address: 135.014.002.024
NMS 5 IP Address: 204.128.146.035
General Traps:
Enterprise Specific Traps: Enable
Link Traps:
Link Traps Interfaces:
--------------------------------------------------------------------------------
Ctrl-a to access these functions, ESC for previous menu
Save
Table A-8, SNMP Trap Options,
February 2001
Traps, for details of SNMP
Current Configuration
SNMP Traps
SNMP TRAPS OPTIONS
Number of Trap Managers: 5
Clear Destination: IMC
Clear Destination: IMC
Clear Destination: IMC
Clear Destination: IMC
Clear Destination: IMC
Both
Both
Network
in Appendix A, Configuration Options , for
Hotwire
Model: 87x5
MainMenu Exit
8700-A2-GB25-10