Remote Send Line Loopback - Paradyne Hotwire 8775 User Manual

Remote Send Line Loopback

A Remote Send Line Loopback sends a line loopback Up or Down command to
the remote unit for 10 seconds. When the remote unit detects the loopback Up
command, it puts itself in line loopback and remains in loopback until it receives a
loopback Down command.
Procedure
To run a Remote Send Line loopback:
The Remote Send Line Loopback cannot be started when any other loopback or a
Send and Monitor 511 test is active on the network interface.
8700-A2-GB25-10
Local
NTU/LTU
Port
Framer
CAP
Interface
1. Position the cursor at the Up or Down selection next to Send Line Loopback on
the Network Tests screen.
2. Press the spacebar to select either Up or Down.
3. Position the cursor at the Send command next to Up or Down selection.
4. Press Enter.
The loopback stops automatically after 10 seconds. You cannot stop the test
manually.
February 2001
Remote
NTU/LTU
Port
Framer
CAP
Interface
5. Testing
EIA-530
All 1s
Port
98-15939
5-5