Self-Test Results Messages; Test Status Messages - Paradyne Hotwire 8775 User Manual

Self-Test Results Messages

The results of the last power-on or reset self-test appear in the middle column of
the System and Test Status screen.
Table 4-2.

Test Status Messages

The Test Status messages in the following table appear in the right column of the
System and Test Status screen.
Table 4-3.
8700-A2-GB25-10
Self-Test Results Messages
Message What Message Indicates
CPU Failed The CPU failed internal
testing.
Device Failed One or more of the unit's
integrated circuit chips has
failed device-level testing.
Failure xxxxxxxx An internal failure occurred.
(xxxxxxxx represents an
8-digit hexadecimal failure
code for use by service
personnel.)
Memory Failed The unit failed memory
verification.
Net DSL Failed, Pt n
The unit failed to loop data on
the network DSL circuit of
Port n .
SYNC Pt Failed, Pt n The unit failed to internally
loop data on the synchronous
Port n .
Passed No errors were detected.
Test Status Messages
Test Status Message Meaning
511 Test Active, Pt n A 511 Test and Monitor is active on the DSL Port n network
interface.
DCLB Test Active, Pt n A Data Channel Loopback test is active on Port n .
DTLB Test Active, Pt n A Data Terminal Loopback test is active on Port n .
Lamp Test Active The Lamp Test is active, causing the LEDs on the front panel to
light.
LLB Test Active, Pt n A network Line Loopback test is active on Port n .
No Test Active No tests are currently running.
RLB Test Active, Pt n A network Repeater Loopback test is active on Port n .
February 2001
4. Monitoring the Unit
What To Do
1. Reset the unit and try again.
2. Call your service
representative for
assistance.
Record the failure code and
contact your service
representative.
1. Reset the unit and try again.
2. Call your service
representative for
assistance.
No action is needed.
4-5