Network Interface Options - Paradyne Hotwire 8775 User Manual

A. Configuration Options

Network Interface Options

For Network Interface Options, refer to
access the Network Interface Options screen, follow this menu selection
sequence:
Table A-1. Network Interface Options (1 of 2)
A-2
Main Menu Configuration
Margin Threshold
Possible Settings: –5db, –4db, –3db, –2db, –1db, 0db, 1db, 2db, 3db, 4db, 5db, 6db,
7db, 8db, 9db, 10db
Default Setting: 0db
Determines the level, expressed in decibels, at which a signal-to-noise margin condition is
recognized.
–5db to 10db – Sets the margin threshold to this value.
Excessive Error Rate Threshold
Possible Settings: 1E–4, 1E–5, 1E–6, 1E–7, 1E–8, 1E–9
Default Setting: 1E–6
Determines the error rate at which an excessive error rate (EER) condition is recognized.
The rate is the ratio of the number of CRC errors to the number of bits received in a
certain period.
1E–4 to 1E–9 – Sets the excessive error rate threshold to this value.
AutoRate
Possible Settings: Enable, Disable
Default Setting: Enable
Determines whether the unit automatically adjusts to the best line rate for conditions, or is
fixed at the rate in the DSL Line Rate field. The automatically set rate cannot exceed DSL
Line Rate.
T
AutoRate is available only when the unit is configured as an LTU.
Enable – The LTU adjusts to the best line rate.
Disable – The LTU's line rate is the selected DSL Line Rate.
February 2001
Table A-1, Network Interface
Current Configuration Network
Options. To
8700-A2-GB25-10