Ip Addressing; Selecting An Ip Addressing Scheme; Configurations Not Running Ip Conservative Software; All Configurations - Paradyne Hotwire 8775 User Manual

IP Addressing

Selecting an IP Addressing Scheme

Your IP addressing scheme depends in part upon whether the management card
controlling the chassis is running IP Conservative software.

Configurations Not Running IP Conservative Software

In a configuration not running IP Conservative software, the NTU's network
interface IP address is assigned through the peer IP address of the LTU's Network
Interface menu.
The termination unit is assigned an IP address and subnet through the DSLAM's
Configuration
assigned, you can use the ATI to assign:
T
T

All Configurations

The NTU obtains its IP address when the PPP link is established over the EOC.
Use the ATI to assign:
T
T
8700-A2-GB25-10
DSL Cards
Peer IP addresses to the four DSL ports. These addresses are used as the IP
addresses of the remote units. See
Appendix A, Configuration Options .
An IP address for each NMS to act as a trap manager. See
Trap Options, in Appendix A, Configuration Options .
An IP address for each NMS. See
Appendix A, Configuration Options .
An IP address for the TFTP server you wish to use to upload and download
configurations. See Configuration Loader
Configuration , and the documentation for your TFTP server.
February 2001
Set IP Address menu. Once the address is
Table A-1, Network Interface Options,
Table A-7, SNMP NMS Security Options,
in Chapter 3, Initial Startup and
8
in
Table A-8, SNMP
in
8-1