Installing The Dsu; Comsphere 3000 Series Carrier, Rear View - Paradyne COMSPHERE DualFlow 3615 User Manual

Installing the DSU

Prior to installing the Model 3616 DualFlow DSU,
install a rear connector plate onto the rear of the
COMSPHERE 3000 Series Carrier (Figure 3-2). Only
after this procedure can the DSU be installed or
de-installed by simply removing it from the carrier.
3615-A2-GB20-40
Figure 3-2. COMSPHERE 3000 Series Carrier, Rear View
"
Procedure
1. At the rear of the carrier, set the tab on the rear
connector plate into one of the slotted grooves on
the carrier's backplane. Loosely fasten the screws.
Make sure the rear connector plate uses the same
slot position intended for the DSU.
2. Loosely fasten the screw attached to the rear
connector plate, allowing for slight adjustment
that may be needed when installing the DSU.
3. Change any default hardware strap settings that
may be required before installing the DSU.
July 1999
Installing the Model 3616 DualFlow DSU
3-5