C-8 Command Error Messages - Paradyne COMSPHERE DualFlow 3615 User Manual

COMSPHERE DualFlow Data Service Units
Error Messages
Table C-8 describes the command error messages;
Table C-9 describes the dial backup error messages.
Message
Conflict w/Envir
Not in Menu
No Response
Command Failed
Inval Selection:
No Valid Choices
C-10
Table C-8
Command Error Messages
Condition
Command conflicts with a test in
progress, or the configuration is
inappropriate for this command, etc.
Command is not in the supported set.
Invalid remote address or remote device
is not powered, connected to network, or
enabled.
Command could not execute and none of
the error messages above apply.
Invalid menu selection based upon
previous selections that caused a menu
to display with no selectable options.
July 1999
Action
1. Check for a test in progress.
2. Either wait for the test to finish or abort
the test.
3. If there is no test in progress, check
configuration options.
Use a valid command.
Check remote address.
If problem cannot be corrected, call your
service representative.
Press any key to return to the top-level
menu.
3615-A2-GB20-40