Paradyne Compshere 3000 Series Installation Manual page 61

To install the ferrite choke on the DTE interface,
network, or power cable:
"
Procedure
1. Pull up on the latch to open the ferrite choke.
2. Place the ferrite choke around the cable as close to
the cable connector as possible.
3. Close the two halves around the cable and snap
the ferrite choke shut.
4. Press down on the plastic latch to secure the ferrite
choke in place around the cable.
EIA-232
Interface
3600
V.35
Interface
NIM
V.35
Cable
Figure 6-10. Examples of Installed Ferrite Chokes, Carrier Rear View
3000-A2-GA31-D0
Refer to Figure 6-10 for examples of installed ferrite
chokes.
Ferrite Choke for
V.32 DBM
or DBM-V
Network Cable
July 1999
5. For the ac power cable or other thin cable, secure
the ferrite choke in place with a cable tie wrap.
Ferrite Choke
Tie
Wrap
Connector
Cable
Tie Wrap
for AC
Power Cable
Circuit Card Installation
Plastic
Latch
496-14820-01
DTE
Ferrite
Choke
6-Port
MUX
Adapter
99-15235-02
6-9