Paradyne Compshere 3000 Series Installation Manual page 51

Installing the 24-Port NIM
The 24-port NIM includes a NIM cover and cable.
"
Procedure
1. Fasten the NIM to the carrier with the four
standoffs provided. See Figure 5-4.
2. Position the NIM cover over the NIM.
3. Fasten the NIM cover in place with the four
screws provided.
Cabling the 24-Port NIM
Connect one end of the short ribbon cable to the 50-pin
connector at the bottom of the NIM. Connect the other
end to P21 (on the right side of the carrier) or P22 (on the
left side of the carrier). See Figure 5-3. Connect a network
interface cable to the 50-pin connector in the middle of
the NIM.
P26
J2
3000-A2-GA31-D0
P20 P19
P25 P24 P23
P22
J1
P21
Figure 5-4. Installing the 24-Port NIM
If a 50-pin cable is . . .
Attached to a 66A
punchdown block
Plugged into a feature
3821-F1-500 adapter cable
Network Interface
P21 or P22
Figure 5-3. Cabling the 24-Port NIM
Standoff
To P23
or P25
To P24
or P26
July 1999
Connecting to the Network
Then . . .
Hardwire the circuits to
the block.
Connect the 24 RJ11C
6-pin cables.
Cable
Short
Ribbon
Cable
496-14798a
NIM Cover
Network
Interface
Module
(NIM)
496-14854a
5-7