Testing The Speaker Panel - Paradyne Compshere 3000 Series Installation Manual

Testing the Speaker Panel

Once the speaker panel is installed, verify that the
speaker is working.
"
Procedure
1. Connect one end of the supplied coiled cable into
the speaker panel's jack labeled Spkr and the
other end into any dial/lease modem's speaker
jack labeled Spkr.
2. If the cabinet has an SDCP, press Select and enter
a valid carrier and slot address for the modem
used in Step 1. The Front Panel status indicator
on the dial/lease modem's faceplate lights,
indicating that it is connected to the SDCP.
3. Using the SDCP, scroll the menu until the Control
branch appears on the LCD.
Phillips-head
Captive
Screws
Modem Speaker
Panel
3000-A2-GA31-D0
Speaker Panel
Mounting
Bracket
#10
Screw
Speaker Jack
SDCP
Figure 3-2. Speaker Panel for Dial/Lease Modems
Installing the Carrier and Assembly Components
4. Access the Control branch and select the Speaker
function.
5. Select a speaker setting of Low, Medium, or High
and place a call to listen to the dialing sequence.
This is only a temporary setting.
Upon a reset, the modem returns
to its default setting of Medium.
To change the default setting,
refer to the device's manual.
If you do not have an SDCP installed and are using
AT commands, use the ATM command to turn the speaker
ON and the ATL command to adjust the speaker volume.
Front Rail
July 1999
NOTE
Carrier
Mounting
Bracket
Captive
Screws
496-13184-05
3-13