Cabinet Setup - Paradyne Compshere 3000 Series Installation Manual

COMSPHERE 3000 Series Carrier

Cabinet Setup

The cabinet is shipped with the following:
Doors (two)
Mounting rails
Two factory-installed ac power strips
Cabinet setup requirements consist of:
Leveling the cabinet once it is in place at your site
and, if needed
Reversing the cabinet doors
Leveling the Cabinet
There are four adjustable leveling feet at the bottom of
the cabinet; these screw up or down, enabling you to
adjust the cabinet to a level position on the floor.
The required tools are a level and an adjustable
crescent wrench.
"
Procedure
1. Place the level against the front door and adjust
the leveling feet until the cabinet stands level
vertically from front to rear.
2. Place the level against one cabinet side and adjust
the leveling feet until the cabinet stands level
vertically from side to side.
2-2
Reversing the Cabinet Doors
The cabinet's front and back hinged doors are installed
on the cabinet frame at the factory to open left-to-right. To
reverse the doors, use the pre-drilled holes on the opposite
side of the frame.
"
Procedure
1. Supporting the door, use a flat-blade screwdriver
to remove the screws from the bottom hinge,
detaching the hinge from the cabinet frame.
2. Supporting the door, remove the screws from the
top hinge, detaching the hinge and the door from
the cabinet frame.
3. Flip the door end-over-end.
4. Holding the door in position on the opposite side,
align the hinge holes with the predrilled holes on
the cabinet frame provided for this purpose. Then,
use the same screws to reattach the door by its
hinges to the cabinet.
July 1999
496-14890
3000-A2-GA31-D0