Paradyne Compshere 3000 Series Installation Manual page 42

COMSPHERE 3000 Series Carrier
Installing the T1 Network Cable Retainer
"
Procedure
1. Ensure that the T1 network cable retainer's rubber
pad is properly attached to the black plastic. This
plastic cable retainer secures the T1 connecting
cable once it is plugged in.
NOTE
Do not install the cable retainer if
you will be installing a Telco
connector cable with a straight
cable entry. Instead, secure this
cable using the screw lock
provided on each side of the
T1 network connector.
2. To install the T1 network cable retainer:
— Insert one slotted leg, with the grooved slot
facing outward, into the larger recessed slot at
the bottom of the T1 connector, and
— Slide it toward the center.
Rubber
Pad
3. Insert the other leg of the cable retainer (with the
groove on top) into the larger recessed slot, then
slide it toward the left.
4-4
496-14385-02
July 1999
4. To open the cable retainer, insert a flathead
screwdriver into the slot on the top and pry it
open. The retainer unfolds, allowing connection of
the cable.
T1 Network
Cable Retainer
5. To lock the retainer in place, refold and snap it
down over the top of the connector cable.
COMSPHERE
3000 Series
Carrier (Rear)
Auxiliary
Backplane
over Slots 9–16
T1 Network
Cable
496-14891
Cable
Retainer
496-14386-03
3000-A2-GA31-D0