Paradyne Compshere 3000 Series Installation Manual page 57

Installing a 6-Port DTE Connector Module
"
Procedure
1. At the rear of the carrier, set the two tabs into the
slotted grooves on the carrier's backplane. The
connector module must use the same slot positions
intended for the device.
NOTE
When installing a DDD NIM and
a DSU with a MUX card, install
the connector module where it
will not interfere with the NIM's
J3 and J4 modular connectors.
2. Insert the screws provided, but do not completely
tighten them until the circuit cards are installed.
See the Modular Circuit Card Installation
page 6-6.
3000-A2-GA31-D0
24-Port DTE Interface Assembly
The eight-slot DTE interface assembly can be mounted
on the left or the right side of the carrier. If you are
installing only one interface assembly, it must be mounted
on the same side as an installed NIM. Refer to the
Installation section of Chapter 5.
"
Procedure
1. Feed the eight tabs at the bottom of the DTE
interface assembly into the slots on the left or right
side of the carrier.
3000 Series
Carrier
section,
2. Insert the screws provided, but do not completely
tighten them until the circuit cards are installed.
See the
page 6-6.
July 1999
Circuit Card Installation
Tabs
Slots
Modular Circuit Card Installation
NIM
24-Port
Interface
Assembly
496-14799a
section,
6-5