Pppoa Connection Setup (6211 Only) - Paradyne 6210 User Manual

To complete the connection you must now click the Apply button. The Apply button
will temporarily save this connection. To make the change permanent, click on
Tools (at the top of the page) and select System Commands. At the System
Commands page, click on Save All.

PPPoA Connection Setup (6211 Only)

PPPoA is defined in the Internet standard RFC 2364. It is a method of
encapsulating PPP packets over ATM cells which are carried over the DSL line.
PPP (Point-to-Point Protocol) is a method of establishing a network session
between network hosts. It usually provides a mechanism of authenticating users.
LLC and VC are two different methods of encapsulating the PPP packet. Contact
your ISP to make sure which encapsulation is being supported.
By selecting PPPoA, you are forcing your modem to act as the termination point
for the PPPoA connection. This frees up your PC resources and allows multiple
users to utilize the PPPoA connection.
To configure the modem for PPPoA:
Procedure
Following is a description of the different options:
6210-A2-GB23-00
1. Click on Setup and then click on New Connection. The default PPPoE
connection setup is displayed.
2. At the Type field select PPPoA and the PPPoA connection setup page is
displayed.
3. Give your PPPoA connection a unique name. The name must not have spaces
and cannot begin with numbers.
4. Select or enter a VPI and VCI (as supplied by your DSL service provider or
your ISP), or click in Auto PVC. (Auto PVC causes the modem to perform
automatic VPI/VCI detection as defined in DSL forum TR-068.)
5. Select NAT and Firewall if you want them active for this connection. Firewall
and NAT services must be enabled. See
6. Select the encapsulation type (LLC or VC); if you are not sure just use the
default mode.
7. Select the quality of service (QOS). Leave the default value if your ISP did not
provide this information. Depending on the QoS you select, you may also
enter:
— PCR (Peak Cell Rate)
— SCR (Sustainable Cell Rate)
— MBS (Maximum Burst Size)
— CDVT (Cell Delay Variation Tolerance)
Username – The username for the PPPoA access. This is provided by your
DSL service provider or your ISP.
January 2005
3. Using the Web Interface
Firewall/NAT Services on page 3-18.
3-7