Leds Blink In A Sequential Pattern; Status Led Continues To Blink; The Status Link Led Is Always Off - Paradyne 6210 User Manual

4. Troubleshooting

LEDs Blink in a Sequential Pattern

This typically means that either the kernel or flash file system is corrupted. Notify
your service representative.

Status LED Continues to Blink

This means that the DSL line is trying to train but for some reason it cannot
establish a valid connection. A possible cause of this is that you are too far away
from the central office. Contact your DSL service provider for further assistance.

The Status Link LED is Always Off

4-2
4. Make sure NAT is enabled if you are using private addresses on the LAN
ports.
1. Make sure you have DSL service. You should receive notification from your
ISP that DSL service is installed. You can usually tell if the service is installed
by listening to the phone line: you will hear some high-pitched noise. If you do
not hear high-pitched noise, contact your ISP.
2. Verify that the phone line is connected directly to the wall and to the line input
on the modem. If the phone line is connected to the phone side of the modem
or you have a splitter installed on the phone line, the Status LED will not come
on.
January 2005 6210-A2-GB23-00