New Connection; Pppoe Connection Setup (6211 Only) - Paradyne 6210 User Manual

Bridge and bridge/router
Table of Contents

Advertisement

New Connection

A new connection is basically a virtual connection. Your modem can support up to
8 different virtual connections. If you have multiple different virtual connections,
you may need to utilize the static and dynamic routing capabilities of the modem to
pass data correctly.

PPPoE Connection Setup (6211 Only)

PPPoE is defined in the Internet standard RFC 2516. It is a method of
encapsulating PPP packets over Ethernet. PPP (Point-to-Point Protocol) is a
method of establishing a network session between network hosts. It usually
provides a mechanism of authenticating users.
To configure the CPE for PPPoE:
Procedure
Following is a description of the different options:
6210-A2-GB23-00
1. Click on Setup and then click on New Connection. The default PPPoE
connection setup is displayed.
2. At the Type field, select PPPoE and the PPPoE Connection Setup page is
displayed.
3. Give your PPPoE connection a unique name. The name must not have spaces
and cannot begin with numbers.
4. Select a PVC Sharing type of Disable, Enable, or VLAN.
5. Select or enter a VPI and VCI (as supplied by your DSL service provider or
your ISP), or click in Auto PVC. (Auto PVC causes the modem to perform
automatic VPI/VCI detection as defined in DSL forum TR-068.) For VLAN,
specify a VLAN ID and priority.
6. Select NAT and Firewall if you want them active for this connection. Firewall
and NAT services must be enabled. See
7. Select the quality of service (QOS). Leave the default value if your ISP did not
provide this information. Depending on the QoS you select, you may also
enter:
— PCR (Peak Cell Rate)
— SCR (Sustainable Cell Rate)
— MBS (Maximum Burst Size)
— CDVT (Cell Delay Variation Tolerance)
Username - The username for the PPPoE access. This is provided by your
DSL service provider or your ISP.
Password - The password for the PPPoE access. This is provided by your DSL
service provider or your ISP.
January 2005
3. Using the Web Interface
Firewall/NAT Services
on page 3-18.
3-5

Advertisement

Table of Contents
loading

This manual is also suitable for:

6211

Table of Contents