Installation Of The Charging Base - Stiga A 500 Instruction Manual

4.5.1. INSTALLATION OF THE CHARGING BASE

CAUTION:
Danger of cutting hands.
ELECTRICAL HAZARD:
Connect the power supply only at the end of
all the installation operations. If necessary
during the installation, turn off the general
power supply.
Requirements and obligations:
• Flat land
• charging base
• Power supply
• Glasses
GLOVES OBLIGATION:
Use protective gloves to avoid
cutting your hands.
The charging base can be installed inside the work area or in an area connected to it by a transition route.
Make sure that the space for installing the charging base is sufficient, in order to have an obstacle-free
zone at least 1.5 metres wide and at least 3 metres long in front of it.
Procedure:
1. Check the installation requirements as indicated in par. 4.3.
2. If necessary, prepare the ground so that the surface of the charging base (A) is at the same level
as the lawn (B), the ground must be perfectly flat and compact in order to avoid deformation of the
surface of the charging base.
30
4. INSTALLATION
• Compact soil
• Fixing screws
• Gloves
GLASSES OBLIGATION:
Use safety glasses to avoid the
danger of dust in the eyes.
A
B
CAUTION:
Danger of dust in
the eyes.
EN