Table of Contents
Advertisement
5.3.8. STARTING THE ROBOT LAWN MOWER
To start up the robot lawn mower, follow the procedure described in par. 5.3.4 "SCHEDULED PROGRAM
SELECTION / SINGLE WORK CYCLE / FORCED RETURN TO DOCKING STATION - MODE
SELECTION BUTTON".
5.4.
FUNCTIONING OF THE DOCKING STATION
The docking station is equipped with an indicator light (N) that lights up in the following manner:
• Warning light o昀昀 : the docking station is powered o昀昀 or the robot is on the base;
• Indicator light 昀氀 ashing slowly: the docking station is not set up correctly;
• Indicator light 昀氀 ashing rapidly: there is a fault in the docking station.
• Indicator light 昀氀 ashing rapidly twice or three times: the docking station has detected a short circuit
on the charging contacts. (See Chapter 7).
5.5.
BATTERY CHARGING
The "BATTERY CHARGING" procedure allows to recharge the robot lawn mower manually.
Requirements and obligations:
• Docking station connected to the mains.
Procedure:
1. Position the robot lawn mower on the docking station (R).
2. Slide the robot lawn mower onto the docking station, until the charging connector (S) is engaged.
3. Press the "STOP" button (A) to open the cover (B) and access the control panel (C).
4. Turn the robot lawn mower on with the "ON/OFF" button (E).
5. When the "BATTERY" icon (O) 昀氀 ashes blue, the robot lawn mower is charging.
6. Close the cover (B).
7. Leave the robot lawn mower to charge for at least the time shown in Par. 4.5.3.
NOTE: Charging the battery before winter storage should be carried out as shown in Par. 6.4.
A
EN
R
C
B
S
N
O
E
5. OPERATION
49
Advertisement
Chapters
Table of Contents
