Stiga A 500 Instruction Manual page 23

• If it is not possible to comply with the above mentioned distances, the virtual return path and the
area behind the docking station must be delimited with impassable barriers (I), if not already in
place.
• The docking station's power cable must be routed outside the cutting area.
• When exiting the charging base, the robot mower normally rotates 180° immediately after
disengaging from the charging contacts. In some special cases, where it is strictly necessary to
install the docking station:
- in proximity of vertical structures that may reduce the quality of the satellite signal.
- in areas where manoeuvring is restricted, which must be delimited by impassable barriers in any
case.
Itis possible to activate a long reverse manoeuvre (Long Exit) via the app. In this case, the robot
lawn mower performs a reverse manoeuvre of 2 m in length before rotating 180°, so that it is better
located both for performing the manoeuvre as well as receiving the satellite signal.
The long reverse function (Long Exit) is to be considered as an aid in certain special installation
conditions, and under no circumstances should it be used to install the docking station under
canopies or inside closed rooms.
NOTE: In some cases, after the 2 metre reverse manoeuvre, the robot lawn mower may still
find itself in sub-optimal satellite signal reception conditions. In this case, the docking station
must be installed elsewhere.
EN
I
4. INSTALLATION
19