Stiga A 500 Instruction Manual page 35

3. Secure the charging base (L) to the ground with the fixing screws (M).
4. Check whether the satellite reference station (A) is connected to the charging base through its
connector:
5. Connect the power supply unit to the charging base and screw in the connector.
6. Connect the power supply plug to the electrical outlet.
7. When the robot lawn mower is not in the charging base, make sure that the indicator light on the
charging base (N) is lit (see Par. 5.4).
WARNING:
The power cable, power supply unit, extension cord and all other electric cables
which do not belong to the product must remain outside the cutting area to
maintain their distance from hazardous moving parts and prevent damage to
cables which may come into contact with live parts.
L
NOTE: If necessary, it is possible to extend the power cable to the charging base by using the
extension cables. It is permitted to use a maximum of two 5-metre extension cables or one
15-metre extension cable (See Chap. 9 "Accessories").
WARNING:
The robot lawn mower needs to receive the satellite signal even while it is inside
the charging base. If a protective cover is to be installed over the charging base,
only original STIGA covers should be used. Do not, under any circumstances,
install metal covers over the charging base.
EN
C M
A
N
4. INSTALLATION
31