Table of Contents
Advertisement
DISPLAY
1.23.2.
Enable Multiple Bev.
1.23.3.
Free
1.24.
Complete menus
1.25.
Grouping Powders
1.25.1.
Enable
1.25.2.
Grouping Powders
1.26.
VM Model
1.27.
Default Menu
1.27.1.
Factory default
1.27.2.
Custom Default
1.27.2.1.
Read Custom
1.27.2.2.
Write Custom
1.28.
System Info
2.
PAYMENT SYSTEMS
...
It allows to enable or disable the beverage keys.
By pressing a disabled key during operation, the message "NOT AVAILABLE" will be
displayed.
enables the free-of-charge dispensing of the multi beverage, even if the machine works upon
payment.
If the parameter is set on NO, machine settings apply to the multi beverage.
Enables selection of whether the entries of the programming menu should be shown fully or
only partially.
It enables creating a group of 2 instant product containers.
The groups of containers can be used when a higher capacity of instant powder is required for a
particular product (e.g. when chocolate is largely used in a certain location, 2 chocolate powder
containers can be dedicated accordingly).
The machine software will be responsible for alternatively starting the two powder motors, to
guarantee equal product consumption in the 2 containers.
To use the instant product groups proceed as follows:
enter the System Management through the Groups option
enable groups management
select the pair of containers you would like to group together
programme the beverage recipe by introducing one of the 2 instant products that have been grouped.
Enables the instant product containers groups
Choosing the powder motor pair to be grouped together
It allows selecting the current model of the vending machine.
The vending machine model is specified on the label located in the inside of the right-hand
side panel.
Management of default values for machine configurations.
The user can create and recall their own configuration.
It allows reverting the programmable parameters to factory preset values.
This operation does not reset the product counter.
Management of the configuration which has been created by the user
Restore on machine the configuration saved by user
Saving the user machine configuration
System Info
This option allows accessing a page showing the overall machine configuration.
The display shows the following information:
FIRST ROW: Sw version ("x.yy.zz" format) / Program CRC ("abcd" format)
Example: "SW v1.02.12/087c"
SECOND ROW: Boot loader version ("xx" format) and name of the file searched for by the
boot loader on the USB key (".s19" extension not displayed)
Example: "Boot 08SAE_DA5P"
THIRD ROW: Memory version ("xxx.yyy." format) / Content CRC ("zzz" format)
Example: "Mem 123.456.789"
The entries of the PAYMENT SYSTEMS are:
Description
English
35
Advertisement
Table of Contents
