Table of Contents
Advertisement
DISPLAY
3.3.
Beverage Preparation
...
3.3.
Sequence
0C00
3.3.
H2O / Coffee
38
3.3.
Just water
110
3.3.
% instant product #:
100
3.3.
% pump #:
100
3.3.
InstProdDelay #:
3.3.
Instant prod. dose #:
55.0
The vending machine is able to dispense 14 beverages.
Each beverage can be prepared by using ground coffee and/or instant products.
Technicians can select the desired products for the recipe (max 4) and their order of use.
Each component is identified by a number or a digit.
Defines with which and the dispensing order of the products composing the beverage.
The possible choices are:
0 =does not dispense any product
1 = dispenses product 1
2 = dispenses product 2
3 = dispenses product 3
4 = dispenses product 4
5 = dispenses product 5
C = dispenses coffee using freshly ground coffee
F = brews "fresh brew" coffee using pre-ground coffee
P = brews espresso coffee using pre-ground coffee
B = dispenses "fresh brew" coffee using freshly ground coffee
W = dispenses hot water
S = disp. steam in Cappuccinatore
Consequently, the combination of "3C00" or "30C0" or "03C0" will always dispense product
3 and coffee beans.
The settings of products making up the beverage will be requested according to the
sequence.
Sets the quantity of water to be dispensed for the programmed coffee type (C or B). The
quantity can be set from "1" to "999".
Defines the amount of hot water to be dispensed.
The quantity can be set from "1" to "999".
It determines the instant powder delivery rate.
The value can be set between 10 and 100.
The lower the value the smaller the powder delivery rate.
It determines the water delivery rate.
The value can be set between 20 and 100.
The lower the value the smaller the water delivery rate.
Important
If the sequence includes several instant products, the sequence "INSTANT PRODUCT -
WATER - DELAY INSTANT PRODUCTS - % OF INSTANT PRODUCT" will be shown
again.
If the setting relative to the instant product ("INSTANT PRODUCT - WATER") means that
the powder dispensing lasts longer than the water dispensing, the vending machine stops
powder dosing (to avoid insufficient rinsing of the mixer) and emits a beep.
Readjust the set parameters in order to have a correct dispensing procedure, i.e. the powder
dispensing should stop a few seconds before the water stops flowing out. This is intended to
allow correct mixer washing.
Delay (in tenths of second) between instant product and water start
This defines the quantity of instant product to be brewed.
Example: "5.0" quantity indicates that the motor of the instant product 3 will be activated for
5 tenths of a second.
The quantity of instant product is adjustable from "0.1 to "500.0" in steps of 0,1.
Brewing of the instant product does not occur when the parameter is set at "000.0" (in this
case water is brewed).
Description
English
39
Advertisement
Table of Contents
