Alarm Clock - Wyse WY-60 User Manual

AlaHTI ClOCk
In the alarm clock accessory you can set two alarm times and enter two
20-character reminder messages. At the set time, the alarm sounds for 30
seconds, and any reminder message is simultaneously displayed on the status
line.
• Note The alarm sounds only during normal terminal operation, not while the
terminal is in WyseWorks or setup mode.
Alarm Clock Display
The alarm clock display shows
• The current time according to the terminal's clock (default 8:00 a.m.)
• Two alarm setting lines—Alarm 1 and Alarm 2—each with a time field
(default 12:00 a.m.), a 20-character message field, and an on/off indicator
field
Setting the Alarm Position the cursor in the appropriate fields:
1 Press the cursor keys or | TAB | or | BACKSPACE] to go from field to field. Pressing
| R E T U R N | (| E N T E R |) moves the cursor to the start of a line.
2 To reset the terminal's clock, enter the current time (12-hour format, including
a.m. or p.m.) in the time field.
3 Enter the desired alarm time in the Alarm 1 or Alarm 2 time field and the desired
message in the message field.
4 In the on/off indicator field, press any key to set the alarm bell to on.
• Note After the alarm sounds, the indicator defaults to off, but the time setting
and message remain until you redefine them or turn off the terminal.
Turning Off the Alarm To turn off the alarm, press 1 SETUP j (| RESET |, | SYS R E Q [, | S E L E C T |). Before you
can resume normal operation or reenter WyseWorks you must press | SETUP [
(| R E S E T [, 1 SYS R E Q |, [ S E L E C T |) again to clear the message displayed on the status
line.