Sony DVCAM DSR-1800 Operating Instructions Manual page 67

Use the following as reference information when setting
the EE OUT PHASE menu item (see page 61).
* THROUGH mode
In this mode, the LTC signal is output with the phase
synchronized with the input time code signal. This mode
is appropriate when recording signals from multiple
devices on a number of VCRs.
When the camcorder is in genlock mode, the time code
precision is +0 frames. When the camcorder is not in
genlock mode, it is +1 frame.
] VIDEO IN
| AUDIO IN
Ml TIME CODE IN
wef) TIME CODE OUT
DSA-1800/1800P (1st unit)
VIDEO IN
a
——i--» ff AUDIO IN
4
'me ff TIME CODE IN
ge== TIME CODE OUT
a
t —DSR-1800/1800P (2nd unit)
'
e @
e e
e e
e @
@ e
a
'
i VIDEO IN
e
——+*» AUDIO IN
8
=e ff TIME CODE IN
DSR-1800/1800P (nth unit)
=== Composite video or S-video signal
——~ Audio signal
sane@ Time code signal
¢ VIDEO INPUT PHASE mode
The time code output signal is synchronized with the
input video signal.
This mode is appropriate when the output from a single
device is recorded on a number of VCRs. The
connections are loop-through connections.
In this mode, the same time code is recorded on all of the
VCRs 1 ton.
VIDEO OUT FF
M VIDEO IN
— VIDEO LOOP THRU
[| TIME CODE IN
E) TIME CODE OUT
DSR-1800/1800P (1st unit)
Output device
(VCR, camera, etc.)
EB) VIDEO IN
E) VIDEO LOOP THRU
ean EB) TIME CODE IN
TIME CODE OUT
[| TIME CODE OUT
DSR-1800/1800P (nth unit)
=——<—~ Composite video or SDI (video and audio) signal
sesa@ Time code signal
Menu Contents
6