Sony DVCAM DSR-1800 Operating Instructions Manual page 35

|
|
Once set, the point A or B time code value is held in the non-volatile memory
of the unit until changed. It is not lost when the unit is powered off.
- When setting point A or B, you can only use a time code value. Even when
COUNTER is selected with the COUNTER SEL button, you cannot use a CNT
value to set point A or B.
To check the point A or B time code value
Press the <=[A] or [B]=> button on the menu control panel. While the button is
held down, the point A or B time code value is displayed on the monitor and in
the time counter display.
If you hold down the <A] and [Bl=> buttons simultaneously, the value shown
is the point B time code value minus the point A time code value. If the point A
time code value is greater than the point B time code value, a minus sign (—) is
shown before the value.
Using the following procedure, you can modify the time code value for point A
or B.
manem |||
1,15 81112 2,3,4,6,10,11
9,7,9,12 13
1 Press the MENU button.
The following menu display appears.
Time counter display
Monitor screen
Playback 35