Sony DVCAM DSR-1800 Operating Instructions Manual page 18

mn
MBIAJBAQ | Jajdeug
18
is used, the built-in 75 Q termination switch turns off
automatically.
The REF. VIDEO OUT connector outputs a reference
video signal, except when i.LINK is selected in the INPUT
SELECT section (see page 11).
© VIDEO OUT 1 and 2 (SUPER) connectors (BNC
type)
These connectors output analog composite video signals.
When the CHARA. DISPLAY menu item (see page 59) is
set to ON (factory default setting), connector 2 (SUPER)
outputs a signal with superimposed text information.
@ S VIDEO OUT connector (4-pin)
This connector outputs an S-video signal with separated Y
(luminance) and C (chroma: 3.58 MHz for DSR-1800 or
4.43 MHz for DSR-1800P) components.
@ COMPONENT VIDEO OUT Y/R-Y/B-Y
connectors (BNC type)
These connectors output analog component video signa
(Y/R-Y/B-Y).
@ TIME CODE IN/OUT connectors (BNC type)
Input SMPTE time code (for DSR-1800) or EBU time
code (for DSR-1800P) externally generated to the IN
connector.
The OUT connector outputs a time code according to tt
operating state of the unit, as follows:
During playback: the playback time code
During recording: the time code generated by the intern
time code generator or the time code input to the TIME
CODE IN connector. When the EE OUT PHASE menu
item (see page 61) is set to MUTE, no time code is outp
Digital signal input/output section (optional DSBK-1801/1802/1803 boards required)
& SDI IN and active through output connectors
Location and Function of Parts
rq DV IN/OUT connector
© SD! OUT connectors
B SDT! (QSDI) IN/OUT connectors
@ DIGITAL AUDIO (AES/EBU) OUT connectors
@ DIGITAL AUDIO (AES/EBU) IN connectors