Sony DVCAM DSR-1800 Operating Instructions Manual page 45

Input an external time code (LTC) signal to the TIME
CODE IN connector, then set the TC MODE menu item
(see page 60) to EXT REGEN.
mode are automatically set as follows:
Advancement mode: FREE RUN
To confirm external synchronization
You can start recording time code from an initial value
which can be set freely (see page 43).
* Use a tape which is recorded in the DVCAM format.
(You cannot use the TC insert function with a tape
recorded in DV format.)
* The time code recording starts from the current tape
position. Cue the tape up beforehand to the required start
position.
° If you use a tape on which ClipLink log data is recorded,
the ClipLink log data will be lost.
1 Open the door on the lower part of the front panel, then
press the MENU button.
ce : Setup menu
AUTO FUNCTION
HOURS METER
Time counter display
Monitor screen
Setting the Time Data
IAD AAA
Maawnin Rita
45