Sony DVCAM DSR-1800 Operating Instructions Manual page 60

DISPLAY CONTROL [Display]: Settings related to Description of settings
indications on the monitor and the unit
PEAK HOLD [>Peak hold]: Set the peak hold time for the OFF [>> OFF] to 1.5 SEC [1.5 sec]: Set the peak hold time ir
audio level meters. the range of OFF (no peak hold) to 1.5 seconds in 0.1
second steps.
Factory default setting: OFF [>> OFF]
OVER DISP HOLD [> Hold OVER]: Determine whether or not | *OFF [>> OFF]: Do not hold the OVER indication display.
to hold the OVER indication display on the audio level ON (HOLD) [>> ON]: Hold the OVER indication display.
meters once the indications light.
With ON selected, once the display is held it will remain held
unless you change the setting to OFF.
BRIGHTNESS [> Brightness]: Set the brightness of front Set brightness as a percentage of the maximum.
panel indicators. 100% [>> 100%]
*75% [>> 75%]
50% [>> 50%]
ALARM [> ALARM]: Determine whether alarm messages are | OFF [>> OFF]: Alarm messages are not issued.
issued or not. *ON [>> ON]: Alarm messages are issued.
REF ALARM [> REF ALARM]: Determine whether alarm OFF [>> OFF]: Alarm messages are not issued.
messages related to reference video signal are issued or |*ON (LIMITED) [>> ON (Limit)]: Alarm messages are issue:
not. only during recording mode, EE mode, and while editing
ON [>> ON]: Alarm messages are issued.
TIME CODE [Time code]: Settings related to the time code | Description of settings
generator
TC MODE [> TC mode]: Determine the time code to use: *INT PRESET [>> PRESET]: Use internal time code with a
internal time code using a preset initial value, regenerated preset initial value.
internal time code (locked to time code read from tape), or | INT REGEN [>> REGEN]: Use internal time code locked to
external time code. time code read from tape.
EXT REGEN [>> EXT]: Use external time code selected as
follows.
¢ When TC is selected
External time code input to the TIME CODE IN
connector
e When VITC is selected
The VITC time code present in the input video signal
When the selected input mode is SDTI or i.LINK (the V:SDT|
SDTI, or i.LINK indicator is lit in the Input selection/audio
mode display section), setting this item to EXT REGEN
causes the internal time code generator to automatically
synchronize with the external time code input to the unit via
the SDTI or i.LINK interface.
*FREE RUN [>> FREE RUN]: Time code generator keeps
running.
REC RUN [>> REC RUN]: Time code generator only runs
while recording.
mn
sBumes nue, p seideug
RUN MODE [> RUN mode]: Select the advancement (RUN)
mode of the time code generator.
Set to FREE RUN when carrying out editing with an editing
control unit. With the REC RUN setting, editing will not be
carried out correctly.
*ON (DF) [>> ON (DF)]: Drop frame mode
OFF (NDF) [>> OFF (NDF)]: Non-drop frame mode
(For DSR-1800 only)
DF MODE [> DF mode]: Select whether the time code
generator and time counter operate in drop frame mode or
non-drop frame mode.
Normally select drop frame mode, to keep in
synchronization with real time. The non-drop frame mode
is useful for example when using computer graphics, and
working on a frame count basis.
Jes,
60 Menu Contents