Sony DVCAM DSR-1800 Operating Instructions Manual page 44

i
}
b. a
4
3:
ra
i
4 +
at
iM
uoiyeiedoQ Bump 40, suonouny yuelueAuOD = ¢ JeIdeuD
44
2 Set the TIME CODE menu items (see page 60) as
shown below.
TC MODE "INT PRESET"
RUN MODE "FREE RUN" or "REC RUN"
DF MODE Normally "ON (DF)"
(for DSR-1800 only)
Press the TC PRESET button on the menu control
panel.
The current setting is shown on the monitor screen and
in the time counter display on the front panel. The
leftmost digit keeps flashing.
One of the following menu screens is displayed on the
monitor depending on the setting made in step 1.
TC PRESET MODE UB PRESET MODE
TCG 00:00:00:00 UBG 00:00:00:00
(1) (WL) KEY
SHIFT : (€) (>) KEY
CLEAR : RESET KEY
() (LI KEY INC/DEC : INC/DEC :
SHIFT : (€) (®) KEY
CLEAR : RESET KEY
DATA SAVE : SET KEY
ABORT : TC PRESET KEY
DATA SAVE : SET KEY
ABORT : TC PRESET KEY
Initial time code value setting User bit setting screen
screen
If you press the TC PRESET button while CNT value
is being displayed, the message "COUNTER MODE
IS SELECTED." will appear on the monitor screen
and "CNT mode!" will appear in the time counter
display on the front panel. If this happens, press the
COUNTER SEL button to light the time data type
indicator "TC" or "U-BIT."
4 Use the <= and => buttons to move the flashing digit
to the value to be changed.
5 Use the 4} and & buttons to-change the value of the
flashing digit.
Enter hexadecimal values (0 to 9, A to F) when setting
user bit data.
6 Repeat steps 4 and 5 until you have set the desired
values for all digits.
To set a value of 00:00:00:00, simply press the RESET
(NO) button.
Setting the Time Data
7 Press the SET (YES) button.
The message "NOW SAVING..." appears on the
monitor screen, "Saving..." appears in the time count
display, and the new settings are stored in memory.
After this saving operation is completed, the monit«
screen and the time counter display return to their
usual status.
The set data may be lost if you power off the unit wh:
the above saving operation is in progress. Wait unti
the saving operation is completed before powering c
Advancement of internal time code
generator
The internal time code generator can advance in either «
two modes, which can be set with the RUN MODE mer
item (see page 60).
FREE RUN: Advancement starts when the data saving
operation is completed.
REC RUN: Advancement starts when recording starts ai
stops when recording stops.
To set the current time as the initial time
code value
In step 2 above, set the RUN MODE menu item to FRE
RUN, then set the current time (format: HH:MM:SS:FF
hours: minutes:seconds:frame number) in step 3 and
subsequent steps.