Commands That Can Be Used in E-mail Text
Use each command according to the following rules:
■
Prefix all commands with "#", and specify the #Password command at the top of the
e-mail.
■
Command lines without "#" are ignored.
■
Write one command on each line and separate each command and parameter with a space
or a tab.
When the same command is written two or more times in one e-mail, the second and
subsequent commands are ignored.
Command
Parameter
#Password
Password
#NetworkInfo
#Status
#SetMsgAddr
Recipient E-mail
address
Example of Commands
1.
When the read only password is "ronly", and to check the printer status:
#Password ronly
#Status
2.
When the full access password is "admin", and to set the recipient e-mail address to
"service@xerox.com":
#Password admin
#SetMsgAddr service@xerox.com
3.
When the full access password is "admin", and to set the recipient e-mail address to
"service@xerox.com", then confirm the setting result on the network settings list:
#Password admin
#SetMsgAddr service@xerox.com
#NetworkInfo
Note:
Describe the "#SetMsgAddr" command before the "#NetworkInfo" command. If
they are written in reverse, the information retrieved by the "#NetworkInfo" command and
the result of executing the "#SetMsgAddr" command may differ.
Description
Use this command at the top of the e-mail when a password
for read only or full access is set. You can omit this command
when the password is not set.
Set this when you want to check information on the network
settings list.
Set this when you want to check the printer status.
Use this command to specify the e-mail address to which
e-mail reports are sent to. This command can only be used
when the full access password is specified by the #Password
command.
Phaser® 6180MFP Multifunction Printer
11-9
Managing the Printer