Output Adjustments - Xerox Phaser 6180MFP User Manual

Output Adjustments

You can change the following output adjustment settings:
■ Collating Copies on page 6-12
■ Output Quality on page 6-12
Collating Copies
When you make several copies of a multi-page document, you can collate the output. For
example, if you are making three single-sided copies of a six-page document, the copies are
printed in this order when you select collated:
1, 2, 3, 4, 5, 6, 1, 2, 3, 4, 5, 6, 1, 2, 3, 4, 5, 6
If you select uncollated, the copies are printed in this order:
1, 1, 1, 2, 2, 2, 3, 3, 3, 4, 4, 4, 5, 5, 5, 6, 6, 6
To select a collating option:
1. On the control panel, press the Copy button.
2. Select , and then press the OK button.
Collated
3. Select or
Uncollated
Note:
The factory default is Uncollated.
Output Quality
The following table describes the two output-quality modes:
Output-Quality Mode
Standard
Enhanced
To change the output-quality mode:
1. On the control panel, press the Copy button.
2. Select
Output Quality
3. Select either
Standard
Note: The factory default is Standard.
, and then press the OK button.
Collated
Type of Copy Job
General-purpose mode for copies. Produces crisp,
bright copies at high speed.
Best mode for high quality copies. Produces very
smooth accurate colors. This mode takes longer to
process and print than Standard mode.
, and then press the OK button.
or , and then press the OK button.
Enhanced
Phaser® 6180MFP Multifunction Printer
6-12
Adjusting Copying Options