Malfunctions Shown On The Display (For The User) - Smeg UG511DUK Translation Of The Original Instructions

14 MALFUNCTIONS SHOWN ON THE DISPLAY (FOR THE USER)

The dishwasher can show a series of malfunctions on display.
After the machine has been switched off and restarted, if the problem is not solved, follow the steps
below:
( FOR A MORE PROFICIENT AFTER-SALES SERVICE, ALWAYS TAKE NOTE OF THE INDICATED
ERROR )
Err04 Tank temperature probe anomaly
Tank water filling anomaly
Err05
Water pump-out anomaly
Err06
(water remains in the dishwasher)
Excessive water level in the tank
Err09
anomaly
Boiler heating anomaly (does not
Err23
heat)
Err24 Boiler temperature probe anomaly
Err25 Boiler water filling anomaly
Err26 Boiler emptying anomaly
Boiler emptying anomaly – with full
Err27
tank
Contact After-sales Service
Check that the water supply tap is open, the
dynamic supply pressure, cleanliness of the inlet
water filter. If the problem still occurs, contact
After-sales Service.
Check that the filters are clean, and that the
drain pipe is not bent, obstructed, narrowed.
Check that the drain pump is not blocked.
If the problem still occurs, contact After-sales
Service.
Contact After-sales Service
Contact After-sales Service
Contact After-sales Service
Check that the water supply tap is open, the
dynamic supply pressure, cleanliness of the inlet
water filter. If the problem still occurs, contact
After-sales Service.
Check that the nozzles of the rinsing spray arms
are not clogged.
If the problem still occurs, contact After-sales
Service.
Contact After-sales Service
19.390.6184.12
Manual rev.
35
25/05/2022
Date