Haier GE PTW600BPR DG Series Technical Service Manual page 57

Knob Index/
Test number
(Displayed on Test Name
7-Segment
Display)
10 Flow
Rate/Pressure
Sensor
12 Drain Pump
13 Lid Switch
14 Spin
15 Agitate
16 Clear all Fault
Codes
Description of test
If tests call for numbers to be shown it will: Display on
7-Segment Display. Turning the cycle knob will index to the
Pressing Start will start the test.
Pressure sensor test will have a timeout.
All valves will turn on.
6 LEDs will blink at start of test.
Stop blinking LEDs as approximate water levels are crossed.
The levels are:
2", 3", 4", 5", 6" and 7" Water valves shut off at this level.
NOTE: To ensure proper flow rate, this test should complete in
less than 3-minutes and 15-seconds. If it takes longer, check
to ensure the incoming water pressure is 20psi minimum at the
washer while the washer is filling, and that the inlet fill screens
are clear of debris.
Pressing Start will toggle the drain pump on and off. Test will
have a (4-minute) timeout for how long drain pump will be on.
The drain pump will turn off when the test is exited.
Pressing Start will start the test.
When the lid is open, the Spin status LED will blink. When the
lid is closed, the Rinse status LED will blink.
Pressing Start will start the test.
Spin test will perform child safety algorithm before it starts to
spin. (Two (2) short drains before locking the lid.) The lid must
be closed to start the test. If lid is open, the Locked LED will
blink.
When mode shift is complete, the washer will ramp up to max
spin speed after first dwelling at 120 RPM and then 450 RPM.
When mode shift is complete, the washer will begin spinning to
max spin speed for the model being tested.
Spin test will have a (4-minute) timeout.
Be sure to only run this test with an empty basket. No OOB
detection during this test.
The spin will stop when the test is exited. The lid will unlock
once the speed reaches 0 after the test is exited.
Pressing Start will start the test. Agitate test will perform child
safety algorithm before it starts to agitate. The lid must be
closed to start the test. If lid is open, the Locked LED will blink.
When started, the mode shift to agitate will occur if required.
When mode shift is complete, the washer will begin agitating.
The test will pause if the lid is opened after starting. The test will
resume on lid close if it was running when opened.
The test will stop when the test is exited.
Pressing Start will clear all Fault Codes.
– 57 –
next or prior test.
(Continued next page)