Haier GE PTW600BPR DG Series Technical Service Manual page 12

Profile 28-in. top load washer
Table of Contents

Advertisement

E
Settings
Individual settings for water temperature (Temp), agitation (Soil), and spin (Spin) can be set
from the minimum (lowest in column) to maximum (highest in column).
NOTE: Longer Spin times typically reduce dryer time/energy usage (i.e.: reduces total energy
when using both a washer and a dryer).
F
Cycle Options
Deep Fill
Select the Deep Fill feature for loads where extra water is desired. The Deep Fill feature is
recommended for special caseloads only, not for typical use.
Press and release the Deep Fill button once before starting the cycle to add 3 addition gal-
lons of water to the wash load. Holding the Deep Fill button for 3-seconds will provide the
deepest fill level possible; this will increase cycle time due to the additional time it takes to fill
the washer. To cancel the option if desired, press the Deep Fill button again.
NOTE: The Deep Fill button can also be pressed after the washer has completed filling and
is in the wash phase if additional water is desired. To stop the extra fill, press the Deep Fill
button again and the water will stop.
Power Pre-wash (on some models)
Ideal for heavily soiled loads, this cycle option works with SmartDispense™ to add a brief
wash, soak and drain cycle to loosen and remove heavy soil before starting the cycle select-
ed.
Tangle Control™ (on some models)
Setting this option will adjust the wash cycle to aid in the prevention of tangling. The cycle
time may increase when this option is selected. NOTE: This option is not allowed for some
cycles.
Auto Soak
This option begins with a brief agitation, soaks for a specified period of time, then moves
through the rest of the cycle automatically. Repeated pressing of the Soak button will scroll
through 15-minute, 30-minute, 1-hour and 2-hour selections and then return back to 0 soak
minutes.
Deep Rinse
Set this option to provide a deep rinse or when using fabric softener. It may change other
settings (e.g., Spin may go to a higher setting) to maximize performance. Option available
on all wash cycles.
Delay Wash
When the Delay Wash button is repeatedly pressed, the delay time is set from 1 (01H) to 9
(09H) hours and back to clear (00H) hours. If the user presses and hold the Delay Wash
button for 3-seconds, it will immediately reset.
Extra Rinse
When extra detergent or bleach to clean heavily soiled clothes is used, use the Extra Rinse
option to better remove additional residues. NOTE: This option is not allowed for some
cycles.
– 12 –
(Continued next page)

Advertisement

Table of Contents
loading

Table of Contents