Haier GE PTW600BPR DG Series Technical Service Manual page 65

Profile 28-in. top load washer
Table of Contents

Advertisement

Name
Description
27 Water
If the lid has been
Accessibility
open continuously for
15-minutes without valves
being on and the tub is
not empty.
Note/Clarification: If filling
with the lid open, the 15-
min. time will begin after
the water valves turn off.
If the lid is opened/closed/
opened during the 15-
min, the 15-min counter
will reset.
29 Suds Lock
Suds lock abatement is
Abatement
requested again after
Failure
already being requested
during the final spin
profile (the cycle is
terminated). The intent
of this is to determine of
the suds lock abatement
algorithm is unsuccessful.
30 Stuck Button
Any key press lasts for
Fault
more than 60-seconds.
NOTE: This will never
be set on 100% cap
touch User Interface (UI)
systems; this only applies
to tactile keys.
Repair Action
• Check for leaking water valves.
• Use Pressure Sensor Test 10 to ensure
correct pressure sensor operation.
• Consumer education on leaving lid open for
more than 15-mins during a cycle.
• Consumer education on leaving sopping wet
items in basket for more than 15-mins.
• Can be caused by starting a cycle with the "no
spin" option selected.
• Ensure basket is able to rotate freely. Check
inner tub sidewalls for anything that can
obstruct basket movement.
• Consumer education on correct detergent
usage.
• Ensure consumer is using the proper amount
of HE detergent.
• Check for proper tactile feedback on each
button and check to make sure control
responds correctly up each button activation.
• Check for proper alignment in installation of
the control board and backsplash.
• Check the clearance between the button and
the backsplash hole.
– 65 –
(Continued next page)

Advertisement

Table of Contents
loading

Table of Contents