Haier GE PTW600BPR DG Series Technical Service Manual page 10

B
Start/Pause
Press Start to begin the cycle. NOTE: Unless Bulky cycle is selected, the lid must be closed
for the washer to start cycle. If the lid is open, "Lid" will scroll across the display. During the
load sensing portion of the cycle, the lid will lock, and "SEnSing" will scroll across the display.
When load sensing is complete, the lid will unlock.
Pressing Pause will unlock the lid (if locked at that time), pause the cycle and the Start indi-
cator light will blink.
To continue the cycle, press Start again. If water remains in the machine, select the Drain
and Spin cycle to drain basket and spin water out of the washer basket. NOTE: Machine will
automatically cancel and drain when water is present, and the lid is left open for 15-minutes
or the unit is left in a paused state for 24-hours with the lid closed. Select cycle and press
Start to begin new cycle.
C
Display and Status Lights
Display: The display shows the approximate time remaining until the end of the cycle.
NOTE: The cycle time is affected by how long it takes the washer to fill. This depends on the
water pressure in the home. The size of the load being washed also significantly impacts
cycle time, with larger loads taking longer.
In addition, this display will, "scroll" the washer status:
• BALANCING
• DELAY
• End
• FILL
• H2O SUPPLY
• LID
• SENSING
• PAUSE
Cycle status lights: Shows whether the washer is in the Pre-wash, Delay, Fill, Soak, Wash,
Rinse or Spin portion of the cycle.
Start of rebalancing cycle to redistribute clothes. Stops after rebal-
ancing is complete.
When Delay Wash is initiated. Replaced with estimated time when
cycle starts.
End of current cycle.
"FILL" will scroll across the display during fill. Afterwards the estimat-
ed end of cycle time is displayed.
Cannot sense water level (water supply possibly turned off).
Cycle stopped because lid is open. Close the lid and press the Start
button if needed.
Sensing out-of-balance condition, waterproof items, or load size and
type before and during fill (normal).
Cycle paused because the lid was opened during start up sequence
or the Start/Pause button was pressed. Press Start button again to
restart the cycle.
– 10 –
(Continued next page)