Haier GE PTW600BPR DG Series Technical Service Manual page 11

NOTE: Cycle Status lights vary by model.
If an out-of-balance condition is detected by the washer, the Spin light will blink during the
remaining portion of the cycle and will stay illuminated for a short time after cycle completion.
When this occurs, the washer is taking actions to correct the out-of-balance condition and
complete the cycle normally. In some cases, the washer may not be able to balance the load
and spin up to full speed. If the load is more wet than normal at the end of the cycle, redis-
tribute the load evenly in the wash basket and run a Drain and Spin cycle.
Feature status lights indicate (see sections F and G for more details):
Pause
Controls
Lid Lock
Wi-Fi (on some
models)
Spin Stop
D
Wash Cycles-Cycle Selector
The wash cycle controls the type of washing process. The cycle selector knob can be turned
in either direction. Turning the knob after starting a cycle will stop the washer and change the
cycle/options to the new selection. Press Start to begin the new cycle selection.
The chart on the next page will help match the items to be washed with the best wash cycle
settings. For optimal performance, select the cycle that most closely matches the items being
washed.
Selections and options shown in bold are the recommended settings for that cycle. Some
cycles and options may not be available on some models.
Failure to closely follow these instructions may result in an abnormal vibrating
and out-of-balance condition that could result in physical injury, property dam-
age, and/or appliance damage.
For Waterproof, Water-Resistant, or Bulky:
• Only use the Bulky (or Delicates) cycle.
• Using other cycles can cause excessive vibration and may result in injury or damage to the wash-
er, walls, or floor.
• Do not mix waterproof and non-waterproof items.
• Read the Owner's Manual for wash cycle details.
Sanitize with Oxi
The Sanitize with Oxi cycle, when using an Oxi additive along with the detergent, is designed to
remove 99.9% of bacteria found in home laundry. Measure the detergent and the Oxi products
carefully. Using the amounts appropriate for a large heavily soiled load, follow the detergent and
the Oxi product label instructions. For the Sanitize With Oxi cycle only, add the clothes first and
then place the detergent and Oxi product directly on top of the load. The washer hot water sup-
ply connection must provide a minimum of 120°F to ensure the effectiveness of this cycle.
NOTE: The default Sanitize With Oxi cycle water temperature can NOT be changed.
Will display when washer is paused between cycles.
The washer is locked and will blink once if you press any button or
turn the cycle knob.
The lid is locked. See the Control Lock description.
Will display when washer is connected via Wi-Fi. Will blink when at-
tempting to connect to a device on the home Wi-Fi.
Indicates wash basket is coasting to a stop following spin. Lid will not
unlock until basket has fully come to a stop.
– 11 –
(Continued next page)