Haier GE PTW600BPR DG Series Technical Service Manual page 62

Profile 28-in. top load washer
Table of Contents

Advertisement

Name
Description
19 User Interface
UI state = IDLE and
(UI) State
water present (pressure >
Timeout
0.520") for 24 hours.
OR
UI state is in any state
except IDLE, RUN, or
DELAY RUN for 24 hours.
20 Critical Flood
Tub volume level exceeds
the critical flood gallons
Level by
limit defined here:
Gallons
Flood Protection
Algorithm.
22 Out of Balance
This fault is set if OOB
(OOB) during
condition is detected
Dry Load
during the dry load sense
Sense
algorithm.
Repair Action
• Check for leaking water valves.
• Use Pressure Sensor Test 10 to ensure
correct pressure sensor operation.
• Consumer education on leaving sopping wet
items in basket for more than 24-hours.
• Pausing the machine for greater than
24-hours can cause this.
• Can be caused by out-of-balance.
• Can be caused by starting a cycle with the "no
spin" option selected.
• Check the output voltage from the pressure
sensor to ensure it matches the water level in
the basket according to the pressure sensor
chart.
• Check pressure tube for trapped water.
• Ensure pressure chamber port is free from
obstruction using drill bit size 1/16-in. by hand
so as not to drill through the inner wall.
Check pressure tube for pinches where it
goes through top cover grommet.
Check pressure tube for trapped water.
Check for any leaking water valves.
Check home water pressure.
Check the output voltage from the pressure
sensor to ensure it matches the water level in
the basket according to the pressure sensor
chart.
• Check for excessively OOB load. CE on how
to distribute load equally balanced, proper
cycle/water level.
• Check the basket for excessive friction or for
being excessively out of round. Basket should
spin freely and without wobble. If friction is
found, remove it. If basket is bad, replace it.
• Run Drain and Spin cycle to ensure basket
reaches final spin speed and the Spin LED
does not blink (a blinking LED indicates that
an OOB was detected during final spin).
• Check to make sure unit is firmly seated on all
four legs, doesn't rock, and is leveled.
• Check that basket assembly is hanging
centered up in lid opening. If not, check
for proper rod and springs (color) and are
properly seated.
• Check the basket for excessive friction or for
being excessively out of round. Basket should
spin freely and without wobble. If friction is
found, remove it. If basket is bad, replace it.
• Check speed sensor for loose connection to
motor.
– 62 –
(Continued next page)

Advertisement

Table of Contents
loading

Table of Contents